Linde Electric Forklift Truck Type 324: E12, E15, E15S, E16S Service Training Manual

This illustrated factory service training manual is designed specifically for the Linde forklift truck 324 series, covering the following models:

• E12
• E15
• E15S
• E16S

In addition to the main manual, this package also includes extra manuals for:

• Pulse Control IV for travel drive in Linde forklift trucks
• Pulse Control for working hydraulics in Linde E-forklift trucks
• Repair instructions for electric motors

The manual is divided into chapters covering:

• Technical data for electric motors, pumps, and fans
• Traction motors
• Traction motors 24 V (E12/15) up to 9/88
• Traction motors 24 V (E12/15) from 10/88
• Traction motors 48 V (E15S/16S)
• Pump motors
• Pump motor for working hydraulics, 24 V (E12/15)
• Pump motor for working hydraulics, 48 V (E15S/16S)
• Pump unit for power steering, 24 V (E12/15)
• Pump unit for power steering, 48 V (E15S/16S)
• Fans for traction motors
• Wiring diagrams for E12/15/15S/16S, type 324
• Wiring diagram (standard) up to 12/88
• Wiring diagram (optional equipment) up to 12/88
• Wiring diagram (standard) from 1/89
• Wiring diagram (optional equipment) from 1/89
• Control circuit
• Connector LI (E12/15/15S/16S)
• Connector L4 (E12/15) for timer
• Pin arrangement L4
• Pin arrangement L4 (E15S/16S) for timer
• Connection of micro-switches bl and b2 for curve switches
• Battery discharge indicator up to 12/84
• Battery dimensions and weights
• Adjusting the electronic system
• Adjusting the zero position of travel switch U25
• Adjusting the travel switch
• Adjusting the control board U200
• Measuring and setting drive current FS
• Testing and setting handbrake current HBS
• Setting run-up time HZ
• Setting braking current RS
• Settings for U200
• Maintenance and repair instructions, removal and refitting of essential components
• Testing of carbon brushes on traction motors and hydraulic pump motors
• Changing the brushes on the traction motor
• Changing the brushes on steering pump units
• Changing the brushes on the hydraulic pump motor
• Complete removing and relifting of the hydraulic pump unit
• Removing and refitting the steering pump unit
• Replacing the brake linings
• Replacing the hydraulic filter
• Removing and relifting the motor with wheel drive
• Fitting new brake disc
• Removing the motor from wheel drive and refitting
• Renewing the shaft seal on the drive end
• Wheel drive, fitting, pinion
• Fitting the motor onto the transmission
• Refitting the wheel drive with electric motor
• Dismounting the steering axle
• Refitting the steering axle
• Hydraulic circuit diagram E12/15/15S/16S for working and steering hydraulics

The manual is 78 pages long and is written in English.